B744V/VL Original Version
This page describes the original versions of the B744V and B744VL transducers, manufactured before 2009. These versions have a clevis pin through the top of the insert. The B744V and B744VL transducers are not mix and match transducers. They all have a fixed 10-meter cable attached and cannot easily be used with brands of equipment other than the one they were made for. Some adapters are available. These original versions are no longer made, but the newer B744V and B744VL models can be installed without changing the original fairing.
The depth and temperature sensors are located inside the bronze body. If the temperature sensor has failed, a replacement active insert should be installed. If the depth sensor fails, the transducer must be replaced.
The transducer measures speed by using a magnetic paddlewheel which triggers a Hall effect integrated circuit inside the bronze body. If your speed sensor is not functioning you should first check that the paddlewheel is intact and turning freely. Damaged paddlewheels can be replaced using available kits. If the speed insert is damaged, it can be replaced with a speed-only insert. If the speed function is not working, but the paddlewheel and insert seem intact, then you will need to install an active insert that contains replacement speed and temperature circuitry. You will also need to use an active insert if the temperature sensor has failed. The active inserts have a cable attached and this is to be spliced into the existing transducer cable using the junction box provided with the insert. Instructions are included.
Before contacting us about parts, make sure you have the Airmar part number from the label on the transducer cable (31-xxx-xx).
All measurements shown are from the very top to the very bottom of the black plastic body.
Showing clevis pin
Long stem version