Manual Hand-Crank Retractable VHF Antenna Mount
Part #GS-800-1
MFG #GS-800-1
AVAILABLE NOW! The new GS-800 VHF Antenna Mount was created specifically to prevent climbing on the boat gunnel to raise and lower a VHF antenna. Lift and descend the antenna from the safety of the deck from under the top. Its smooth operation, attractive machined aluminum frame and cast stainless-steel rotator make this item a must for any boater.
• Safe, no-hassle raising and lowering of a VHF antenna
• No more climbing on T-tops or gunnels
• Standard 1"-14 thread (male) shaft to accept standard VHF antennas
• Machined / Anodized aluminum body
• Light brushed finish
• Water-resistance IP66 rating
• Sealed piston
• Polished Type-316L stainless steel crank handle
• Folding crank handle locks flush into base
• Threaded shaft for consistent lift and descent
• Delrin bearings for smooth operation
• Roller bearings in crank assembly
• Mounts through up to 2" thick hardtops
• Includes 4" x 1/4" round backing plate (hardware not included)
• Pairs with 6º Wedge Plate (WP-800-900), which is sold separately
• Made in the USA
• 1-year limited warranty
- Brand: Taco MetalsCountry of Origin: USAExterior Color: SilverRetract Method: ManualRetractable housing: YesExterior Finish: BrushedBase Dimensions: 104mm (4.10")Installed Height: 0.11m (4.5")
- (1) Grand Slam 800 mount
- (1) Aluminum backing plate
- (1) Drill template
- (3) Vinyl tubing spacers
Required - Not Included:
- Safety Glasses
- Power Drill
- Screw Gun (Optional)
- Masking Tape & Pencil
- 1/4" Drill Bit
- 2-1/2" Hole Saw
- Three 1/4-20 Flat, Phillips Head Screws
- Three 1/4-20 Nylon Locking Nuts
- Marine-grade Sealant
