Battery Harness with Fuse for DCM100-01

Part #FC01

MFG #FC01

Features

Included with the DCM100

For Powering:

1. Yellow Wire: One end to pin #7 (VPWR-) on the DCM100 and other end to vessel ground (Note: The terminal should either be at the same voltage as pin #6 (VSENS-) or less).
2. Red Wire: First end to pin #8 (VPWR+) on the DCM100 and other end to source of 9-32 VDC power (Note: This wire may or may not be connected to the same place as the red wire from the Battery Sense Cable).

For Battery Sensing:

1. Yellow Wire: One end to pin #6 (VSENS-) on the DCM100 and other end to negative terminal of the battery or DC source (May or may not be same as vessel ground; should either be at the same voltage as pin #7 (VPWR-) or more).
2. Red Wire: First end to pin #5 (VSENS+) on the DCM100 and other end to positive terminal of battery or DC source.

FC01 cables are shipped with 1 Ampere fuses installed. This is the largest amperage fuses recommended; any larger could cause damage to the unit.

Specifications

Documents

Prop 65