Manual Hand-Crank Retractable Mount with Stern Light
Part #GS-900-1
MFG #GS-900-1
AVAILABLE NOW! Our new Grand Slam 900 Masthead Anchor Light was created specifically for the safety and convenience of today’s boater. Climbing on the boat gunnel to raise and lower a masthead anchor light is dangerous, time consuming and frustrating. The GS-900 allows boat operators to lift and descend this navigational requirement from the safety of the deck, right under the top and without ever having to climb on the gunnel again. Simply extend the crank handle and rotate the light to the upright position or back to its stowed, towing location. The light runs on 12 volts and consists of four 3-watt LED Cree chips driven by two Mean Well drivers. Its smooth operation, attractive machined aluminum frame and cast stainless-steel rotator make this item a must for any boater.
- Safe, no-hassle raising and lowering of an masthead anchor light
- Ideal for boats 39' in length or shorter (12 meters or shorter)
- Certified USCG-required for 3 NM
- Standard 1"-14 thread (male) shaft
- LED light and shaft included
- Water-resistance IP66 rating
- Sealed piston
- Machined / Anodized aluminum body with a light brushed finish
- Polished Type-316L stainless steel crank handle
- Folding crank handle locks flush into base
- Threaded shaft for consistent lift and descent
- Delrin bearings for smooth operation
- Roller bearings in crank assembly
- Mounts through up to 2" thick hardtops
- Includes 4" x 1/4" round backing plate (hardware not included)
- Pairs with 6º Wedge Plate (WP-800-900), which is sold separately
- Includes 32.75" of tube
- Light tube length allows for modification by installer to exact height
- 1-year limited warranty
- Brand: Taco MetalsRetract Method: ManualRetractable housing: YesExterior Color: SilverExterior Finish: BrushedInstalled Height: 0.11m (4.5")Base Dimensions: 108mm (4.25")Country of Origin: USA
- Grand Slam 900 Mount
- Light Assembly
- 32.75" tube
- Aluminum backing plate
- Drill Template
- Vinyl tubing spacers
Required - Not Included:
- Safety Glasses
- Power Drill
- Screw Gun (Optional)
- Masking Tape
- 1/4" Drill Bit
- 2-1/2" Hole Saw
- Three 1/4-20 Flat, Phillips Head Screws
- Three 1/4-20 Nylon Locking Nuts
- Marine-Grade Sealant
- Pencil
- Three Marine-Grade #18 Guage Wire (Length Based on Application)
