Mix and Match Cables for 600W Transducers

Mix and Match 600W transducers are made as a common base transducer with a short (2m) cable attached, plus an interchangeable longer (8m) brand-specific adapter cable.

The short pigtail attached to the transducer ends in an Airmar 5-pin female connector. The adapter cables have a matching Airmar 5-pin male connector (shown below) at one end and the correct connector for a specific brand of electronics at the other end.

Both parts are needed for an installation. If the user changes equipment brand at some later time, the transducer can be left in place and the adapter cable replaced.

Mix and Match 600W transducers include the B117, B45, B60, P319, P66*, P79, SS505, and SS60. (* not all models)

A 12m (40') extension cable (part MM-5P-5P) is available with one male and one female 5-pin connector.

Note that 600W Mix and Match cables cannot be used with 1kw transducers.

Mix and Match 600W System
600W mix and match cable
5-pin connector

Available Adapter Cables

All the available 600W Mix and Match adapter cables are listed below.

Connector Connector Code Cable Part # Application
N/A MM-0 For bare wire depth and temperature units
-2 MM-2 For Autohelm ST50 depth only units. 2-Pin male connector.
N/A MM-2CN For Certek and Navico depth only units. 2-Pin female connector.
-3 MM-3 For older depth-only units with Fuji connector. 3-Pin female connector.
-6G MM-6DO For Garmin depth-only units. 6-Pin female connector.
-6G MM-6DT For Garmin depth and temperature units. 6-Pin female connector.
-6N MM-6NAV For Simrad/Navman/Northstar depth and temperature units. 6-Pin female connector. This cable looks identical to the Garmin cables but is wired differently.
-7 MM-7 For older Simrad, Raytheon and JRC depth and temperature units. 7-Pin female connector.
-8F MM-8 For older Furuno and Si-Tex depth and temperature units. 8-Pin female connector. (For speed/temp see MM-ST8 below)
-8G MM-8G For newer Garmin depth and temperature units. 8-Pin female connector.
-8S MM-8S For Si-Tex CVS 126/128, SVS 650/750, CVS 1410 depth and temperature units. 8-Pin female connector.
-10F MM-10FUR For newer Furuno depth and temperature units. 10-Pin female connector.
-10N MM-10NS For Northstar 490S, 491. 10-Pin male connector.
-18HB MM-18HB For newer Humminbird and former Geonav depth and temperature units. 18-Pin male connector.
-BB N/A All Standard Horizon 600W transducers are hard-wired and are NOT available in a Mix and Match version.
-BL MM-DT-LOW For Lowrance/Simrad depth and temperature units. 7-Pin male 'blue' connector.
-FISO MM-FISO For Raymarine ST40 and ST60 depth instruments. Mini spade connectors.
-HB MM-HB For Humminbird depth and temperature units. #9 square male connector.
-RCA MM-RCA For Datamarine depth only units. Single male connector.
-RAY MM-RAY For Raymarine DSM300 and compatible depth and temperature units. 'Radar' female connector.
-RAYA MM-RAYA For Raymarine newer depth and temperature series. 6/9-Pin male connector.
-8F MM-ST8 For older Furuno and Si-Tex speed and temperature units. 8-Pin female connector.