Mix and Match Cables for 1kW Transducers

Mix and Match 1kW transducers are made as a common base transducer with a short (2m) cable attached, plus an interchangeable longer (8m) brand-specific adapter cable.

The short pigtail attached to the transducer ends in an Airmar 9-pin female connector. The adapter cables have a matching Airmar 9-pin male connector (shown below) at one end and the correct connector for a specific brand of electronics at the other end.

Both parts are needed for an installation. If the user changes equipment brand at some later time, the transducer can be left in place and the adapter cable replaced.

Mix and Match 1kW transducers include the B164, B258, B260, M260, PM260, SS164, SS260, SS270W, TM258 AND TM260.

A 6m (20') extension cable (part MM1-EXT) is available with one male and one female 9-pin connector.

Note that 1kW Mix and Match cables cannot be used with 600W transducers.

Mix and Match 1kW System
600W mix and match cable
5-pin connector

Available Adapter Cables

All the available 1kW Mix and Match adapter cables are listed below.

Connector Connector Code Cable Part # Application
-6G MM1-DO-6G For Garmin depth-only units. 6-Pin female connector.
-6G MM1-DST-6G For Garmin depth and temperature units. 6-Pin female connector.
-6N MM1-DST-6N For Simrad/Navman/Northstar depth and temperature units. 6-Pin female connector. This cable looks identical to the Garmin cables but is wired differently.
-7 MM1-DST-7 For older Simrad, Raytheon and JRC depth and temperature units. 7-Pin female connector.
-8F MM1-DST-8F For older Furuno and Si-Tex depth and temperature units. 8-Pin female connector.
-8G MM1-DST-8G For newer Garmin depth and temperature units. 8-Pin female connector.
-8S MM1-DST-8S For Si-Tex CVS 126/128, SVS 650/750, CVS 1410 depth and temperature units. 8-Pin female connector.
-10F MM1-DST-10F For newer Furuno depth and temperature units. 10-Pin female connector.
-14HB MM1-DST-14HB For Humminbird. 14-Pin female connector.
-18HB MM1-DST-18HB For newer Humminbird and former Geonav depth and temperature units. 18-Pin male connector.
-BB MM1-DST-BB For Standard Horizon depth and temperature units, and Si-Tex ES502. 8-Pin male connector.
-BL MM1-DST-BL For Lowrance/Simrad depth and temperature units. 7-Pin male 'blue' connector.
-RAY MM1-DST-RAY For Raymarine DSM300 and compatible depth and temperature units. 'Radar' female connector.
-RAYA MM1-DST-RAYA For Raymarine newer depth and temperature series. 6/9-Pin male connector.
-HB MM1-DT-HB For Humminbird depth and temperature units. #9 square male connector.