• Search:

600W Mix & Match Transducers

Mix & Match 600W transducers are made in two parts. The base transducers are generic models that will work with a wide variety of different equipment. These are indicted by the suffix 'MM' (e.g. B117-MM). Base transducers have a 2m cable attached and this cable ends in a female 5-pin connector.

To install an 'MM' transducer you will also need a 600W adapter cable for a specific brand of equipment. Mix & Match 600W adapter cables have a male 5-pin connector at one end and a brand-specific connector at the other end. They are 8m long.

If a user changes sonar or fishfinder equipment to a different brand the transducer can be left in place. Only the adapter cable needs to be changed.

Base transducers with just a 2m pigtail are sold as '-MM' models. Kits consisting of a base transducer plus a 600W cable for a specific equipment brand are also available (e.g. B117-8G is a kit containing 1 x B117-MM transducer plus 1 x MM-8G cable).

Mix and Match 600W System
Part Part # Description Brochure Installation
B60-12-MM

B60-20-MM
Low-profile thru-hull 600W 50/200kHz bronze model with either 12° or 20° tilt.

Depth and temperature.

This transducer can be used with any 600W Mix and Match Cable.
B117-MM Low-profile thru-hull 600W 50/200kHz bronze model with zero tilt.

Depth and temperature.

This transducer can be used with any 600W Mix and Match Cable.
P66-MM Transom-mount 600W 50/200kHz plastic model with bracket.

Depth, speed and temperature.

This transducer can be used with the MM-6G, MM-8G, MM-10FUR, MM-RAY, MM-RAYA, MM-HB and MM-18HB cables. All other P66 variants are only available with fixed cables.
P79-MM In-hull 600W 50/200kHz model with tank.

Depth only, no temperature sensor.

This transducer can be used with any 600W Mix and Match Cable.
P319-MM Low-profile thru-hull 600W 50/200kHz plastic model with zero tilt.

Depth and temperature.

This transducer can be used with any 600W Mix and Match Cable.
SS60-12-MM

SS60-20-MM
Low-profile thru-hull 600W 50/200kHz stainless steel model with either 12° or 20° tilt.

Depth and temperature.

This transducer can be used with any 600W Mix and Match Cable.